Mas-Hamilton CEX -07 User Manual

1INSTALLATIONINSTRUCTIONSX-08TM/CEX-08T MType 1FHIGH SECURITY ELECTRONIC LOCK

102. Feed the cables through the outer (larger) tube from the flared end. Seatthe tube into position on the tube retainer on the back of the lock case

11INSTALLATION OF THE CABLES1. Open the ZIF (Zero Insertion Force) seal cover and move the ZIF connectorlocking actuators outward to their open positi

12Figure 4 - Generator Zebra StripINSTALLATION OF GENERATORCABLE AND CABLE GUIDES1. Place the generator cable into the dialring housing recess contai

13INSTALLATION OF THE DIALRING COVER1. Align the dial ring cover with the dial ringso the generator is at the five o’clockposition and the four aligni

144. Slide the dial hub onto the spindle,turning the hub slightly to align thegenerator drive gear teeth. Hold thecam and spindle in place whileinstal

154. Place the Dial Hub Locating Gageover the spindle and between the dialhub assembly and the bushing in thedial ring cover. This sets up an initial0

16Note:Assure that the retainingring gap is aligned with thesetscrews and that an equalamount of the retaining ring isexposed around the hub so the di

17INSTALLING THE COVER LOCK ASSEMBLYWARNING: Failure to verify that the lock is operational beforeinstalling the cover lock pin assembly may cause a l

18RESET COVERT ENTRY (CE) CONDITION FOR CEX-08When the CEX-08 lock is powered up (dial left) after installation, it may displayCovert Entry (CE). This

19APPENDIX ATUBE RETAINER POSITIONSThe tube retainer must be positioned so the cables come through the notch inthe retainer.

2Table of ContentsINTRODUCTION ... 3BASIC TOOLS AND MATERIALS NEEDED .

20Door Thickness Cable Exit Bolt Position Position4.5 3 Left2.5 1 Right3/4 2 DownAPPENDIX BCABLE ROUTING DIAGRAMSUse the following diagrams to route

21

22www.mas-hamilton.com805-D Newtown Circle, Lexington, KY 40511Phone (888) 950-4715 or (606) 253-4744 FAX (606) 281-5766Technical Support: (800) 950-4

3INTRODUCTIONPlease read all instructions before you install and use your Model X-08/CEX-08lock. This will help you avoid unnecessary costs and concer

4LOCK PARTS FOR INSTALLATION1. Lock Assembly2. Dial Ring Assembly3. Dial4. Spindle5. Dial Hub AssemblyINSTALLATION KIT CONTENTS1. Rubber Vise Clamp2.

5TEMPLATEA template is provided as an aid for locating, drilling, and tapping the lock caseand dial ring mounting screw holes relative to the spindle

6PREPARATION FOR NEW INSTALLATION OF THE LOCK1. Use the template to establish the exact relative locations of all of thenecessary mounting holes for t

7INSTALLATIONPRELIMINARY LOCK INSTALLATION1. Remove the two screws from the lock assembly cover and remove theback cover.WARNING:The electronics in th

8CUTTING THE TUBESWarning:The end of the large tube that is to be discarded must befrom the plain (unflared) end of the tube. The end of the small t

96. Install the inner tube on the lock case.Feed the cables through the outertube and install the outer tube on thelock case. Measure and mark theinne